Technology

Ideas That Can Be Useful When Setting Up a Wireless Security System

If you’re one of the bold and handy types who has opted to install a wireless security system, you may find that doing so might be a challenge. Possible concerns include how window and door sensors work and where to put your equipment. A wireless security system can be installed more quickly than a hard-wired one, but there are still a few things to consider before you start.

First, you should consider the specifics of where everything will go. For instance, It would be best to put the control panel in a high-traffic, convenient spot in your house. If you want to protect your home from intruders, don’t put the control panel where it can be seen from outside. The most you can hope for is a control panel that is out of sight from outsiders but accessible to everyone living in the house. Next, remember that while the system is wireless, you will still need to plug in your control panel for it to work, so position the unit near an outlet when determining where to install equipment.

Planning also lets you consider where to put things like motion detectors and sensors. Install the door and window sensors in high-traffic, easily accessible areas. Be strategic about where you put your sensors because they won’t cover all your doors and windows. Specifically, you should install sensors in windows your kids can’t reach or that your next-door neighbors can’t see through. Your front and back doors, in particular, should be equipped with door sensors.

The equipment installation is the following step once careful planning has been completed. The brand and model of your equipment will determine how it should be set up, but there are specific general guidelines you may stick to regardless. For instance, if you’re installing a control panel, you might think twice about hooking its power line into an outlet on the outside of a wall, where a burglar could quickly unplug it. You’ll also need to write code for the control panel and the alarms. Both are typically programmed by following the in-box instructions and opening the right panel with a little screwdriver.

The door and window sensors setup process is essentially complete once installation has begun. The standard components of a sensor to unlock a door or window are a magnet and a transmitter. The transmitter should be placed on a solid, immovable surface like a window or door frame. The magnet then needs to be attached to the mechanism. That’s the glass panel or door you need to watch.

After installing the control panel, sensors, and motion detectors, you should check their functionality. If your home is located near many radios or other transmission towers, the system may experience interference. A hardwired security system may be necessary in that circumstance. In any case, rigorous system testing is essential after installation. To ensure your security system is in top shape in case of a break-in, you should test all entrance points and detect zones.

Gavyn Smith contributes to Secure24Seven as an associate editor. More articles can be found if you’re interested.

admin